Tom_Hamburg
TCP Rider

Without ABS. Once installed a map on which procedure should use? just unplug the cable from the motor? And keep in motion for a few minutes?

Hi I wanted a tips I have a spid triple 2011 # 471846 mono only approved exhaust zard final original as the rest comes out of homes that mapping do you recommend? When unloading the map from the bike over the tuneecu big how do I disconnect the computer from the bata bike or do I do the other procedure Thanks.

Salve dopo tante prove sono riuscito a salvare il programma tueECU SUL COMPIUTER ADESSO STO ASPETTANDO DI RIcevere ic cavo collegamento, ho anche scaricato i draiv per connettere il cavo. Però non riesco a capire come devo fare per caricare le mappe ho scaricato delle mappe nella cartella dove a sua volta ho scaricato tuneECU ma come devo fare poi per aggiornare la centralina con queste mappe? quando mi connetto , mi vengono visualizzate in automatico su TuNECU o ci sono delle opzioni su programma che mi consente di vederle (Dove trovo le mappe da scaricare? )

hi
My Speed Triple 2006, VIN 276816, Keihin, map 20100, have connected with TuneEcu_1.9.6 and I have realized that when I select the menù test and I select the tests and regulations I don't succeed in performing the single tests. It tells me that the function is not supported. Precise that the diagnostic one and the change of the maps work.
Can you help me?
Thanks

Hi,
The green TPS- light is only for Keihin models.

Sagem models, the procedure is as follows:
1. Ignition and Run switch on but engine off
2. Double-click the Reset TPS button
3. This sets closed throttle position to a temporary high value.
4. Start engine and let idle long enough for the ECU to trim the value down to match the set target idle RPM (ca. 30 seconds)

Read the Manual :-)) here http://www.tomhamburg.net/TuneECU_It/tasks.html

and here http://www.tomhamburg.net/TuneECU_It/mapedit.html

BR, Tom

And here: http://www.tuneecu.com/TuneECU_It/tests.html

allright i did it and the reset has been done. but tps indicator never turns green but remains greyed out even after many minutes. this said the tps is at 0.0 but what is trange is that everything about the tps seems to be kinda "off-line". btw thx for your precious help :)

Go into the test window, and click below on the left side by double-clicking "Reset TPS.

Hi,
Go into the test window, and click below on the left side by double-clicking "Reset TPS.

BR, Tom

hi Tom i've a question for you ;)
i've just mapped my speed triple with triumph high mount race map and everything was fine.
then i was told to make a reset of tps but in the menu "reset tps" is greyed out and i can't do it. this said i must say i'am using the last version of tuneecu and my speed is my1999.
thx in advance for the answer ;) have a nice day.

Hi Frank,

Very nice, thank you. :-)

BR, Tom