ciao tom,ma una mappa per speed triple 1050 2007 con il serbatoio in plastica che sia per scarico basso completo,no sai,no lambda e filtro aria sportivo,esiste????
grazie
Visualizzazione Stampabile
ciao tom,ma una mappa per speed triple 1050 2007 con il serbatoio in plastica che sia per scarico basso completo,no sai,no lambda e filtro aria sportivo,esiste????
grazie
Tiger 1050 del 2009, con scarico Leovince senza db-killer quale mappa caricare? Inoltre, quando si deve togliere e quando re-inserire il fusibile delle luci? Grazieeee
@Spetro and Dorio,
please write in simple english.
Unfortunately I can not speak Italian and the Google translator is no real help.
BR, Tom
Ok Tom, I have a Tiger 1050 '09 with Leovince SBK without db-killer, which map upload? And also when I must remove the fuse of the lights and when I must put it back? Sorry for my english and thank you!!!
hi Tom,i need a map to upload on my speed triple 1050 2007 with plastic tank.
i only found maps for low complete exhaust system and no sai but nothing for complete exhaust system and aftermarket racing air filter.have you got something??can you tell me where i can find those maps???
thanks and bye from sunny triple italy:coool:
a questo punto sono d'obbligo le foto, dettagliate precise (insomma che si vede qualcosa...) di tutto sto coso che hai fatto....dovrai condividere no?.....;)
Hi Dorio,
Especially for the LeoVince SBK, we have no map. But you can try the 20545(with SAI) or the 20546 (without SAI), which should be closest to your configuration.
The fuse you must remove, before you download or upload a map. The fuse put you before the "Reset Adaption" and before you start the engine.
BR, Tom
Hi SPETTRO,Citazione:
Originariamente Scritto da Dorio
What have you for a complete exhaust system, then? Which VIN has your Speedy (the last six digits)?
Incidentally, you can turn on again the "SAI" in every maps.
All maps that we have for 3- and 4 cyl. models, you can find here http://www.tomhamburg.net/Tune_List.html
and here http://www.tomhamburg.net/Custom_Tune_list.html
More we can not offer.
BR, Tom
Citazione:
Originariamente Scritto da SPETTRO
Hi Tom,
since you're so kind to reply, I write you my config so you can help me choose a map:
Tiger 1050
K&N air filter
SC-Project high pass exhaust with modded DBKiller (got some holes all along it)
Modded airbox (open on both sides and enlarged in the center - engine oil circuit switched outside airbox)
No cat, SAI still in position
Do you confirm this TPS adaption method?
1) fuse off, download map
2) turn off the key, wait until the bike "moans"
3) fuse on, turn on the key and wait for tuneecu to connect (green light)
4) click on "reset adaption" and wait till the bike stops "moaning"
5) turn on ignition and wait till the fan goes on, then another 12 mins
6) turn off ignition and wait 2/3 mins before using it.
Correct?
ricordati che dopo ogni mappa sul 1050 si vede fare il reset tps e adattamento...
Hi,
For your configuration I can only recommend the dynamometer.
Reset adaption:
After each download
1. Turn the ignition off and back on again.
2. Wait 10 seconds and turn the ignition off again. Put back the fuse.
3. Turn the ignition on. Wait until TuneECU has connected automatically and select Reset Adaption from the ECU menu.
4. Start the engine and let it idle until the TPS light in the status bar becomes green – around 10 to 15 minutes. Sometimes it may take a little longer than 15 minutes.
Another way:
After download
1. Turn the ignition off and back on again.
2. Wait 10 seconds and turn the ignition off again. Put back the fuse.
3. Turn the ignition on. Wait until TuneECU has connected automatically and select Reset Adaption from the ECU menu.
4.Start the engine, let it idle and wait till the fan goes on, then another 12 minutes.
BR, Tom
Citazione:
Originariamente Scritto da HARRRRRRRRRR